Edging device

Send

Finishing cuts with trim tape is a simple enough way to give the trim edges of the material a flat and neat appearance.

Using the edging device, you can process oblique neckline sections, armholes, open sections of products without lining neatly and quickly enough. Instructions are given for the PFAFF device. Other manufacturers of sewing equipment may have a similar device.
So, cut out the finishing braid (slanting inlay) 24 mm wide without an average crease.

Remove the presser foot holder from the machine along with the presser foot and install the edging device.
Obliquely cut the front end of the trim tape.
Bring the sharp corner of the braid into the "snail" of the edging device and pull it out from the back.
Adjust the position of the needle so that the needle sticks into the material at a distance of 1-1.5 mm from the fold of the curved braid.
Sew a few centimeters along the braid.
Then lay the trimmed edge of the edging material between the folded braid in the notch of the edging device. During sewing, the finishing braid will bend itself around the trimmed edge of the fabric.

When sewing knitwear, the trim is cut out not obliquely, but across. An oblique edging, stitched in this way can serve as a strap in sundresses, tops.
An additional decorative effect can be obtained by using a zigzag or decorative stitch.

Send