Share
Pin
Tweet
Send
Share
Send
It doesn't matter where the nautical-style table is decorated. The main thing is that this scenery will constantly remind you of a recent vacation.
For tissue holder: blue porous rubber 3 mm thick ● white and blue acrylic paints ● black thin permanent pencil ● red varnish pencil ● 13 and 35 cm of wire in unpainted paper braid 2 mm thick ● blue napkins.
For a sailboat: white mass for modeling Micro Wave ● blue wooden beads (diameter 8 and 10 mm) ● white, blue and blue acrylic paint skewers 8 and 22 cm long ● blue yarn ● 1.5 and 1 cm floral wire with a diameter of 1.4 mm tevek fabric ( 45 g / m²) ● tracing paper ● simple pencil ● ruler ● scissors ● thick needle ● loop and sticks for modeling ● flat brushes No. 12 and 6 ● pole with straw and clay ● tracing paper ● strong glue ● gun with hot glue ● nippers ● adhesive tape .
DESCRIPTION OF WORK
1. Motives should be increased from the motif sheet to the appropriate size, transferred using a simple pencil to tracing paper and cut with allowances for cuts, then transferred to cardboard using carbon paper and cut precisely along the contours.Place the template for slippers on the blue porous rubber, the template for the lifebuoy on white rubber, fix the templates with tape and cut out (Fig. 1).
2. Acc. paint slippers and a lifebuoy with acrylic paints and leave the paints to dry completely. Names should be written in red lacquer pencil, the contours should be done in black pencil. Cut the paper-braided wire into two different-sized pieces. Wrap a long section twice on a paper roller, carefully slide it off the roller, wrap the remaining end three times around the circle, and cut off excess wire if necessary. Bend the second segment in the middle (Fig. 2).
3. With a thick needle, make three holes in slippers, pass a bent short length of wire through them, slightly bend on the back side and glue with hot glue. Then stick the previously prepared napkin ring (Fig. 3).
4. Wrap corrugated cardboard around the candlestick and stick it on. With one end of a paper-braided wire, firmly wrap a lifebuoy, lower the wire into a candlestick. Twist a lifebuoy around the other end of the wire. Fill the candlestick with sand and put a tea candle in the candlestick.
5. The contours of the motif of the sailboat should be transferred from the sheet of motifs to cardboard and cut. Knead the mass for modeling, roll into a part approx. 4-5 cm and lay it on the template. Straighten the contour with a knife. Using the modeling loop, hollow out the interior of the sailboat. Moisten one finger in water and smooth the edges and all the irregularities of the sailboat.From the thick floristic wire, bend two hooks for securing the sail. Acc. Photo hooks set in a still soft hull of the sailboat. With a skewer skewer, make a hole for the mast (Fig. 4).
6. Acc. mass manufacturer's instructions leave the sailboat until the mass has completely dried. Then paint the sailboat with acrylics. Put a wooden bead on a skewer skewer and stick it on. The motives of the sail and the flag reshoot from the sheet of motives and cut. Stick the sail on the kebab skewer. Attach a small flag to the top of the sail. Attach the sail at the bottom corners to the hooks with blue thread for sewing.
Model from Burda magazine "My Favorite Hobby" 01/2014.
Photo: burdastyle.
Material prepared by: Elena Karpova
Share
Pin
Tweet
Send
Share
Send
